Parameters" → "Name; Parameters" → "Save To File; Parameters" → "Restore From File - Danfoss VLT5000 SyncPos Operating Instructions Manual

■ ■ ■ ■ ■ "PARAMETERS" → "NAME"
You can also enter a name for each VLT in addition
to the number or change an existing name with this
function. Click on "CONTROLLER" → → → → →
"PARAMETERS" → → → → → "NAME" and select the VLT that
you want to start in the subsequent dialog field:
In the field "NAME" enter a name for the VLT (no
longer than 8 characters) or overwrite the existing
name and click on "OK". . . . .
■ ■ ■ ■ ■ "PARAMETERS" → "SAVE TO FILE"
With "PARAMETERS" → → → → → "SAVE TO FILE" you save
the user parameters including the arrays in a file
with the extension ".cnf". This way you can quickly
load the parameters in another VLT or re-load them
in the VLT at any subsequent time, for example after
deleting the EEPROM.
Click on "SAVE AS" and enter a name in the subse-
quent dialog field or confirm the file name. The sug-
gested filename contains the date and time to be
safe from overwriting actual parameters in case of
restoring from file.
MG.10.J8.02 – VLT is a registered Danfoss trade mark
Programmable SyncPos motion controller
■ ■ ■ ■ ■ "PARAMETERS" → "RESTORE FROM FILE"
Click on "PARAMETERS" → → → → → "RESTORE FROM FILE"
and select the VLT in which the data should be
loaded.
Then select the file and click on "OPEN". The user
parameters saved, including the arrays, are imme-
diately loaded in the VLT.
63