■ ■ ■ ■ ■ Appendix
A short glossary explains used terms.
Get a quick overview on news in Version 2.5x and in
the corresponding versions of the SyncPos Motion
Controller in the appendix. These are primarily the
necessary extensions and a modified GUI to use the
SyncPos program in MCT10 mode.
Please consider also the news around marker filter
and marker correction, which provide the current
version.
Experienced users will find detailed information in
the technical reference material for example the
„Array Structure of CAM Profiles".
Plus, the handbook ends with a detailed index for a
direct navigation.
MG.10.J8.02 – VLT is a registered Danfoss trade mark
Programmable SyncPos motion controller
■ ■ ■ ■ ■ Conventions
The information in this manual follows the system
and uses the typographical features described
below to the greatest extent possible:
Menus and functions
Menus and functions are printed in normal text with
capitals, for example: "CONTROLLER" → → → → →
"PARAMETERS". . . . .
Commands and parameters
Commands and parameter names are written in
capitals, for example: AXEND and KPROP;
Parameters are printed in bold faced italics, for
Proportional factor
Proportional factor
example: Proportional factor
Proportional factor.
Proportional factor
Variables
Variables are written in small letters, when they are
being quoted they are emphasized with italics, for
example: timeout or timeout.
Keys
The names of keys and function keys are emphasi-
zed in brackets, for example the control key [CNTL]
key (or just [CNTL]), the [ESC] key or the [F1] key.
Cross references
Cross references to other parts of the text are under-
lined in the manual and are also marked in color in
the online help, for example EXECUTE.
7