Edit" Menu; Undo; Cut; Copy" And "Paste - Danfoss VLT5000 SyncPos Operating Instructions Manual

■ ■ ■ ■ ■ "EDIT" menu
The "EDIT" menu offers the necessary editing help
for programming. Most of these commands can
also be reached via certain keys and key combi-
nations, as is usual in Windows.
When you are writing your program use the tabula-
tors and the different colors to visually
structure your program. The tab increments are
permanently set.
Marking text
Point to the position where the marking should begin
and pull the mouse cursor over the text. If only one
word should be marked, simply double-click on the
corresponding word.
You can expand marked text in all directions using the
shortcuts listed; for example, with [SHIFT] + [→] by
one character to the right, with [CNTL] + [SHIFT] +
[→] key to the end of the word, with [SHIFT] + [END]
to the end of the line, etc. The various possibilities
can be found in the List of shortcuts.
Deleting text
Single characters can be deleted either with the
[DEL] key (which deletes character-by-character to
the right of the cursor) or with the [BACKSPACE] key
(which deletes character-by-character to the left of
the cursor). If you are deleting words or lines which
have been marked, both keys have the same effect.
Line number
Within your program you can use the line numbers
for orientation purposes. For example, the syntax
check not only places the cursor in the correspon-
ding line, but also names the line number contai-
ning the incorrect command.
The current line number can be found in the status
bar, for example 13:1. This means that the cursor is
located in line 13 at position 1.
MG.10.J8.02 – VLT is a registered Danfoss trade mark
Programmable SyncPos motion controller
Context menu
Click on the right mouse key and then the "EDIT"
menu is available as a context menu (only for
Windows 95).
Context menus appear in the window at the loca-
tion where you are currently working.
Close the context menu by clicking outside of the
context menu without having selected a command.
Or press [ESC].
■ ■ ■ ■ ■ "UNDO"
Click on "EDIT" and "UNDO", if you want to undo
the last command. By clicking on "UNDO" again,
you can restore the command which was undone.
This can also be accomplished with the key com-
bination [CNTL] + [Z] or [ALT] + [BACKSPACE].
■ ■ ■ ■ ■ "CUT"
With "CUT" it is possible to copy and delete text.
Mark the desired text fragment and click on "CUT"
or on the icon. The text will be temporarily
saved for inserting. With the next copy command
the text stored in the temporary memory is auto-
matically overwritten.
The key combination [CNTL] + [DEL] also serves
the same function.
■ ■ ■ ■ ■ "COPY" and "PASTE"
Mark the desired text fragment and click on "COPY"
or on the icon, the marked text is copied to the
notepad. Move the cursor to the position where the
text is to be inserted and click on "INSERT" or on the
icon.
The key combination [CNTL] + [INSERT] serves the
same purpose.
■ ■ ■ ■ ■ "FIND" and "REPLACE"
Find and replace is realized in accordance with the
Windows conventions and supplemented by some
useful functions.
Click on "EDIT" → "FIND" or press [CNTL] + [F] and
enter the term searched into the following dialog field.
Use [F3] to jump from one site found to the next one.
53