Fuji Electric FCX-AII-V5 series Instructions Manual And Service Instructions page 58

M
⑥
M
56
%
SPAN
⑦
M
%
SPAN
⑧
M
%
SPAN
⑨
M
⑩
A-2 Span (URV) calibration
• Press the key on the screen
calibration mode.
The measured value and unit on the screen ( ) are
"SPAN" light up.
• Apply the actual input pressure on the screen
ter checking the measured value, press the
• "SPAN" blinks on the screen
the screen to perform a span calibration at the in-
put pressure at the time.
To perform a span calibration at a point other than
100%, input an appropriate set value (%) ( ) with
the and keys, and press the
Setting range
• Select whether the span calibration value setting is
saved on the screen
Press the key to save the span calibration value
setting and return to the screen
Press the or key to cancel the setting and return
to the screen .
• Check that the span calibration was performed as in-
tended.
Press the key to perform a span calibration again.
Press the or key to move to the next screen for
item name selection.
to select the span
key.
. Press the key on
key.
.
.
TN5FCXA2V5h-E
. Af-