Fuji Electric FCX-AII-V5 series Instructions Manual And Service Instructions page 53

①
③
M
④
TN5FCXA2V5h-E
M
M
M
%
%
M
M
Menu 8 : Output mode
The output mode is used to select the proportional
mode (proportional to input differential pressure) or
for the output signal (4 to 20 mA) of the differential
②
pressure transmitter only.
In the square root extraction mode, you can set the
cut point of low cut and the modes below the cut point.
8-1 oUT Md : Change of output mode
• Press the
screen for changing output mode (
②
• You can select the proportional or square root extrac-
tion mode on the screen
Select LIN (proportional mode) or SQR (square root
extraction mode) with the
key.
• Select whether the output mode setting is saved on
the screen
Press the
⑤
Press the
8-2 CUT Pt : Low cut point setting
If you select the square root mode, you can set the
low cut point.
Cut point is adjustable within the range of 0.00 to
⑥
20.00%. Note that if the cut point is set to a small
value around 0%, even a minute differential pressure
point is used for improving the measurement in case
⑦
• Press the
screen for setting the low cut point (
• You can set and change the low cut point by inputting
the numerical values with the
screen .
Settable range: 0.00 to 20.0%
• Select whether the cut point setting is saved on the
screen .
Press the
Press the
key on the screen
.
or key and press the
.
key to save the output mode setting.
or key to cancel the setting.
key on the screen
and
key to save the cut point setting.
or key to cancel the setting.
to display the
).
to display the
).
keys on the
51