Installation - Fuji Electric FCX-AII-V5 series Instructions Manual And Service Instructions

3.1 Installation

During the unpacking of the transmitter, check the conformity of the transmitter and all the ac-
cessories.
Before installation, the customer must check the compatibility of the wetted parts for the applica-
The transmitter can be installed on a 2" tube or wall mounted.
Note :
For the wall mounting, the customer has to supply the M8 bolting.
Please refer to the data sheets for the outline dimension drawings of the transmitters.
DANGER
INDICATION
- The transmitter is heavy. Be careful when handling it.
DANGER
- The indicated installation and the wiring conditions of the transmitter must
- A wrong manipulation can be the reason of a disfunction of the transmitter.
- During installation, make sure that no part which could be the reason of the
- The isolating valves and manifold must correspond to the maximum pres-
- The pipes need to be according the process temperature and the pressure
- Membrane are very sensitive. Be careful during the manipulation.
- Do not bend excessiviely the capillary
Bracket mounting
Mount the bracket on the transmitter as shown below.
FKC, FKG and FKA models
Transmitter
Process flange
12
If the transmitter is not used soon after delivery, then leave it packed and store it in
be strictly followed.
disfunction or a danger is located inside the electronics housing.
The local indicator position must not be changed
The position of the electronics housing must not be changed
sure in the pipe. If the valves and the connections do not correspond to the
standards.
Bracket
Plain washer
Spring washer
Mounting bolt
(M8x12)
FKD, FKB and FKM models
Transmitter
Bracket
Plain washer
Spring washer
Mounting bolt
(M8 12)
TN5FCXA2V5h-E