Automatic Start Test - Intec Argus 3u plus Manual

12.1 Automatic Start test

You should check the required parameters (e.g. BERT
measurement time and error level, see Page 120 and Page
120) before the automatic test series is begun.
ARGUS 3u plus/3u NT
12 Automatic Test
Use the< > to select Start
↓
(in the example, the new test
is saved in record number 2).
Enter Own number - on
accesses using the DSS1
protocol - also
remote number.
Use the < > to select the
↓
service.
(needed for
suppl.serv.test)
Start test
During the test series, the
first three lines in the display
will reflect the Single test
currently being run.
To interrupt the test, press
< >.
ABORT
enter a
the
101