Table of Contents
Advertisement
15 Configuration
The ARGUS can be configured to suit your special
requirements. The default (factory) settings can be restored
by selecting "Reset" (see page 131 Reset).
15.1 Trace/Remote
The ARGUS remains active and either saves the data from
the D-channel (all of the D-channel messages sent to and
received from the network) in its internal Flash memory or
passes the data directly to the connected PC. The Remote
function is optional.
ARGUS 3u plus/3u NT
15 Configuration
In the Main menu, use the <
>
↓
Select Configuration.
Use the <
> to select
↓
Trace/remote.
Auto PC sync.: Even after it
is switched on again, the
ARGUS remains in Trace
mode and passes D-channel
data to the PC ("Trace" LED
on continuously).
Manual
PC
sync.:
ARGUS is set to Trace mode
and will pass D-channel data
to the PC until it is switched
off. When it is switched on
again, it will not return to
Trace mode.
Recording:
the
D-channel
data is stored in the internal
Flash memory (the "Trace"
LED flashes slowly)
Confirm the entry
The
113
Advertisement
Table of Contents
