Intec Argus 3u plus Manual page 87

Procedure for an Incoming Call (ISDN)
An incoming call can be taken at any time even when a test
(e.g. BERT) is in process (see "Simultaneously Starting
Several Tests" on page 95.).
The ARGUS will signal an incoming call with an audible tone
and a message on the display.
On a P-MP access, you can use the Call acceptance (see
"Call Acceptance" on page 118.) function to configure the
ARGUS to only signal incoming calls which are addressed to
the MSN that corresponds to your own call number. This
function can only be used when your own call number has
been entered into the ARGUS's speed-dialing memory (see
"Saving Call Numbers" on page 129.) and the incoming call
has a destination MSN.
Reject call
Charge information in NT mode (optional):
In NT mode, the ARGUS will – for incoming calls – send
advice of charges in accordance with DSS1 as units and as
currency (in euro).
ARGUS 3u plus/3u NT
10 Connection
The ARGUS displays the
service (Tel.), the number of
the caller (02351907070), the
B-channel used (B01) and
the number called (90700).
The ARGUS will display the
number called
completely, if the Alerting
mode is set to manual
.
(see Page 116).
-Key: View
information (if available)
Accepting call
Use the < TM > softkey to
start the Test Manager.
(see Page 94).
Use the > to view
↓
<
additional information.
Clearing the connection
(DDI)
additional
89