Table of Contents
Advertisement
BRI
termination
Call parameter On the user-side (ARGUS in TE
Services
ARGUS 3u plus/3u NT
You can add terminating resistors to a
BRI access. This setting will not be
saved.
Default setting:
TE mode / Permanent circuit: no
terminating resistor is switched in
mode), two different parameters can
be set for a call setup (in ISDN):
1. Type of number (TON) for the CGN
(=CGPN) or CDN (=CDPN) element of
a SETUP signal
Network-side: Net CGN TON /
Net-CDN-TON
User-side: User CGN TON /
User CDN TON
2. Numbering Plan for the CGN
(=CGPN) or CDN (=CDPN) element of
a SETUP signal
Network-side: Net-CGN-NP/
Net-CDN-NP
User-side: User CGN NP /
User-CDN-NP
Possible settings:
For
TON:
unknown,
national, network spec., subscriber,
abbreviated.
For NP: unknown, ISDN/telephony,
data, telex, national stand., private
Up to three user-specific services
(user spec.1 to user spec.3) can
entered and saved. For each "user
spec. service", you must enter the info-
elements BCAP, HLC and LLC in
hexadecimal. To do so, use the keypad
and the < A . . F > softkey (e.g. to enter
a "C", press the softkey three times;
for a "F", press it six times).
15 Configuration
international,
117
Advertisement
Table of Contents
