Table of Contents
Advertisement
15 Configuration
Settings in ISDN:
Display
Name on the
ARGUS
Protocol
Alerting mode
116
Comment
As an alternative to automatic protocol
determination (setting: Automatically),
you can also set the Layer-3 D-
channel protocol manually.
The ARGUS will save the protocol
setting permanently, i.e. it will use this
protocol the next time that it is
switched on.
You can specify whether, for an
incoming call on a BRI point- to-point
access, the ARGUS should only
display the access number without
extension or the complete number with
extension.
If it is set to "Manual", the ARGUS will
display the extension (An incoming call
will be signaled. The ARGUS will send
the Layer 3 message "Alert" when it
accepts the call. The digits of the
extension that have been sent by this
point will be displayed.).
An incoming call in the
mode
Manual
answered within 20 seconds
or it will be lost. Furthermore,
you should not that the remote
subscriber will not hear a
ringing tone.
If it is set to Automatically,
the ARGUS will only display the
access number without extension or,
depending on the configuration of the
access in the exchange, it may not
display the number called at all.
ARGUS 3u plus/3u NT
must
be
Advertisement
Table of Contents
