Intec Argus 3u plus Manual page 32

8 Select the Access Mode
also possible to run a BERT in the D-channel.
In this case, the channel select window will open:
On a BRI access:
Start Test Manager (see Page 94).
Once it is over, the ARGUS will display the results of the
BERT ( see "Start BERT" on page 60 ).
34
With the < > , select the
↓
channel
Selecting a B-channel (e.g
64k)
Enter the B-channel on the
keypad.
.
Confirm the selected channel
and start the BERT.
The ARGUS will display
- the bit pattern (e.g. 2^15)
- the channel / bit rate used
(e.g. B02/1984k)
- the remaining test time in
Hours: Minutes: Seconds
(e.g. 00:24:12)
- the bit errors that have
occurred (e.g. 2)
- Synchronicity of the
bit pattern (synchron)
- the LOS-counter (e.g. 0)
.
Use the <ERROR > softkey to
insert artificial bit errors to test
the reliability of the BERT.
Use the <TM > softkey to
ARGUS 3u plus/3u NT