Table of Contents
Advertisement
The series of this LSI has twenty-six general I/O ports and four input-only ports. Port 8 is a large
current port, which can drive 20 mA (@V
these ports can become an input port immediately after a reset. They can also be used as I/O pins
of the on-chip peripheral modules or external interrupt input pins, and these functions can be
switched depending on the register settings. The registers for selecting these functions can be
divided into two types: those included in I/O ports and those included in each on-chip peripheral
module. General I/O registers are comprised of the port control register for controlling
inputs/outputs and the port data register for storing output data and can select inputs/outputs in bit
units. For functions in each port, see appendix C.1, I/O Port Block Diagrams. For the execution of
bit manipulation instructions to the port control register and port data register, see 2.8.3, Bit
Manipulation Instruction.
9.1
Port 1
Port 1 is a general I/O port also functioning as IRQ interrupt input pins, output pin, and a timer V
input pin. Figure 9-1 shows its pin configuration.
Port 1 has the following registers. For details on register addresses and register states during each
process, refer to appendix B, Internal I/O Register.
• Port mode register 1(PMR1)
• Port control register 1(PCR1)
• Port data register 1(PDR1)
• Port pull-up control register 1(PUCR1)
Section 9 I/O Ports
= 1.5 V) when a low level signal is output. Any of
OL
Port 1
Figure 9-1 Port 1 Pin Configuration
P17/
/TRGV
P16
P15
P14/
P12
P11
P10
Rev. 1.0, 03/01, page 89 of 280
Advertisement
Table of Contents
