Installing The Internal Cooling Fan - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 56. Removing the internal cooling fan
Next steps
1 Follow the procedure listed in
2 Install the internal cooling

Installing the internal cooling fan

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 If installed, remove the front
Steps
1 Hold the cooling fan by the sides with the cable end facing the bottom of the system.
2 Align the four tabs on the internal cooling fan with the four slots on the system wall.
3 Press and slide the internal cooling fan into the slots until the release tab locks into place.
4 Connect the internal cooling fan power cable to the connector on the system board.
Figure 57. Installing the internal cooling fan
Next steps
1 Install the air shroud.
After working inside your
fan.
Safety instructions.
Before working inside your
bezel.
system.
system.
Installing and removing system components 109