Cooling Fans; Removing The Internal Cooling Fan - Dell EMC PowerEdge T440 Installation And Service Manual

Figure 55. Installing a memory module
Next steps
1 Install the air shroud
2 Follow the procedure listed in
3 To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS >
Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed
memory.
4 If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
5 Run the system memory test in system diagnostics.

Cooling fans

Removing the internal cooling fan

Prerequisites
CAUTION: Never operate your system with the internal cooling fan removed. The system can overheat and result in shutdown of
the system and loss of data.
CAUTION: Do not operate the system with the cover removed for a duration exceeding 5 minutes.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
Steps
1 Disconnect the internal cooling fan power cable from the system board.
2 Holding the internal cooling fan, press the release tab, and slide the cooling fan out in the direction of the arrow marked on the fan.
CAUTION: Do not remove or install the internal cooling fan by holding the fan blades.
108 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.