Dell EMC PowerEdge T440 Installation And Service Manual page 141

Figure 92. Installing the system board
4 Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Next steps
1 Replace the following:
a Trusted Platform Module (TPM)
b Memory modules
c Processors and heat sink modules
d Internal USB key
e vFlash/IDSDM module
f Integrated storage controller card
g Expansion cards, if installed
h Expansion card holder
i GPU card holder
j Air shroud
2 Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured by using the cable
securing bracket.
3 Follow the procedure listed in
4 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the
Restore section.
b If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag using Easy Restore
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the
5 Import your new or existing iDRAC Enterprise license.
For more information, see iDRAC User's Guide, at
After working inside your system.
section.
www.dell.com/poweredgemanuals
Restoring the Service Tag using Easy
Upgrading the Trusted Platform Module
Installing and removing system components
section.
141