Steps
1
Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
2
Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
Figure 66. Removing the M.2 SSD module
Next step
Replace the M.2 SSD
module.
Installing the M.2 SSD module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the air
shroud.
4
Remove the BOSS card.
NOTE:
The procedure to remove the BOSS card is similar to the removing an expansion card.
Steps
1
Connect the M.2 SSD module to the connector on the BOSS card.
2
Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
117