System Feet; Removing The System Feet - Dell EMC PowerEdge T440 Installation And Service Manual

NOTE: There are two bezel keys attached to the back of the bezel.
2 Insert the bezel tabs into the slots in the chassis.
3 Press the release latch, and push the bezel toward the system until the bezel locks into place.
4 Using the key lock the bezel.
Figure 17. Installing the front bezel

System feet

Removing the system feet

Prerequisites
NOTE: It is recommended that you remove the system feet only when you are converting the system from the tower mode to the
rack mode, or when you are replacing the system feet with the wheel assembly.
1 Follow the safety guidelines listed in
2 Place the system on its side on a flat, stable surface.
3 Rotate the system feet inward.
Step
Using the Phillips #2 screwdriver, remove the screw that secures the foot to the base of the system.
a Repeat the above step for the 3 remaining feet.
66 Installing and removing system components
Safety instructions.