Dell EMC PowerEdge T440 Installation And Service Manual page 123

3 Remove the air shroud.
4 Remove the processor and heat sink
Steps
1 Place the heat sink with the processor side facing up.
2 Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3 Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 71. Loosening the processor bracket
4 Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor tray.
5 Flex the outer edges of the bracket to release the bracket from the processor.
NOTE: Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
module.
Installing and removing system components 123