Installing The Internal Cooling Fan - Dell EMC PowerEdge T340 Installation And Service Manual

1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
Steps
1. Press the release tabs on the fan cable connector and disconnect it from the connector on the system board.
2. Holding the fan, press the release tab, and slide the fan out in the direction of the arrow marked on the fan.
Figure 54. Removing the internal cooling fan
CAUTION: Do not remove or install the fan by holding the fan blades.
Next steps
1. Replace the internal fan.

Installing the internal cooling fan

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud
Steps
1. Align the four tabs on the fan with the four slots on the system wall.
2. Press and slide the fan into the slots until the release tab locks into place.
3. Connect the fan power cable connector to the connector on the system board.
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 57