Caster Wheels - Optional; Removing Caster Wheels - Dell EMC PowerEdge T440 Installation And Service Manual

3 cable retention lock
4 power interposer board
5 power supply unit cage
6 fan
7 processor 2 socket
8 processor 1
9 backplane
Caster wheels – optional

Removing caster wheels

Prerequisites
1 Follow the safety guidelines listed in
2 Place the system on a flat, stable surface.
3 Extend the wheels beyond the edge of the surface.
Steps
1 Using the Phillips #2 screwdriver, loosen the captive screw that secures the front wheel unit to the base of the system.
2 Push the front wheel unit toward the rear of the system to release the retention hooks, and pull out the front wheel unit.
3 Loosen the screw that secures the back wheel unit to the base of the chassis.
4 Push the rear wheel unit toward the front of the system to release the retention hooks, and pull out the rear wheel unit.
Figure 22. Removing caster wheels
Next step
Install the caster wheels or the system
70 Installing and removing system components
Safety instructions.
feet, as applicable.