Dell EMC PowerEdge T440 Installation And Service Manual page 126

5 Place the heat sink on the processor and push down on the base of the heat sink until the bracket locks onto the heat sink.
NOTE:
• Ensure that the two guide pin holes on the bracket match the guide holes on the heat sink.
• Do not press on the heat sink fins.
• Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the bracket before placing the heat
sink onto the processor and bracket.
Figure 75. Installing the heat sink onto the processor
Next steps
1 Install the processor and heat sink
2 Install the air shroud.
3 Follow the procedure listed in
126 Installing and removing system components
module.
After working inside your system.