Installing A Drive Blank - Dell EMC PowerEdge T440 Installation And Service Manual

CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Press the release button, and slide the drive blank out of the drive slot.
Figure 28. Removing a drive blank
Next step
1 Install a drive or a drive blank.

Installing a drive blank

The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical.
Prerequisites
1 Follow the safety guidelines listed in
2 If installed, remove the front
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
76 Installing and removing system components
Safety instructions.
bezel.