Removing The Processor From The Processor And Heat Sink Module - Dell EMC PowerEdge T440 Installation And Service Manual

3 Set the PHM aside with the processor side facing up.
Figure 70. Removing the processor and heat sink module
Next step
Install the processor and heat sink
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE: Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
122 Installing and removing system components
module.
Safety instructions.
Before working inside your system.