Interconnecting Bico Outputs - Siemens SINAMICS S120 Getting Started

Fundamentals
4.3 BICO interconnections
2. Select the parameter that you want to connect.
If connectable bits of the parameter are available, they are displayed in a drop-down list.
Figure 4-3
3. Select the parameter bit that you want to connect.
4. Confirm with OK.
The connection dialog closes.
Result
The binector or connector input is connected to the selected parameter (bit).
4.3.3

Interconnecting BICO outputs

Use the connection dialog to connect binector or connector outputs.
Connecting a signal
To make a connection, proceed as follows:
1. Click the binector or connector icon of the signal that you want to connect (
A connection dialog for the selection of the possible parameters opens. The drive object
for which you want to make an interconnection is displayed automatically in the "Drive
object" drop-down list on the right.
54
BICO dialog: Parameter bits opened
Getting Started, 12/2018, 6SL3097-5AG30-0BP0
or ).