Siemens SINAMICS S120 Getting Started page 155

Setting the technological application and selection of the motor data identification
1. Select one of the following applications in the "Technology application" (p0500) drop-
down list:
– [0] Standard drive (VECTOR)
– [1] Pumps and fans
– [2] Encoderless control down to f = 0 (passive loads)
– [3] Dynamic response in the field-weakening range
– [4] Approach with high breakaway torque
– [5] High load inertia
2. In the drop-down list "Motor data identification and rotating measurement" (p1900), select
how the motor data identification is to be carried out for a stopped motor:
– [0] Disabled
– [1] Motor data ident. (standstill) and speed controller opt.
– [2] Motor data identification (standstill)
Motors from the motor list
For motors with DRIVE-CLiQ interface or motors from the motor list (see Chapter "Inserting
and specifying motors from the motor list (Page 88)"), no additional entries are required
when automatically calculating the motor/controller parameters.
Third-party motors
Motor and controller parameters must first be calculated for third-party motors and motors
that are not in the motor list.
Getting Started, 12/2018, 6SL3097-5AG30-0BP0
Performing basic parameterization
6.3 Drive axes
153