Inserting An Infeed Unit; Inserting And Specifying An Infeed Unit - Siemens SINAMICS S120 Getting Started

Commissioning
5.4 Creating a project offline in Startdrive
Note
Comparing and possibly changing version numbers
When creating a drive device, the current firmware version is always suggested. It is
possible that the suggested firmware version does not match the version number of your
memory card in the drive device. If the version numbers do not match, it will not be
possible to subsequently go ONLINE. Therefore, please observe the following notes:
• Observe the version number displayed in the drop-down list "Version" (to the right in
• When required, change the version number using the "Version" drop-down list.
4. When required, enter a different device name in the input field at the top left, and then
click "OK".
If the "Open device view" checkbox is activated, the device view is opened automatically
in Startdrive when creating the drive.
Result
The drive unit is inserted.
5.4.3

Inserting an infeed unit

5.4.3.1

Inserting and specifying an infeed unit

Preconditions
● A project has been created.
● The Control Unit is inserted in the device configuration.
Note
Sequence
Generally, the infeed is inserted in the configuration immediately after the drive in the device
view. In this case, the infeed is also automatically wired to the drive (X100).
You can also insert an infeed at a later point in time (for example, after the Motor Module).
The infeed is then no longer automatically wired because the standard interface X100
intended for the infeed is already occupied (e.g. with the Motor Module).
In this case, the device configuration must be changed manually. You can wire the infeed
manually to a free interface. You can also change the wiring of the drive object that is
currently linked to X100 of the drive, to a different interface. X100 would then be free again
and when the infeed is inserted, it is automatically linked to X100.
72
the dialog), and ensure that the displayed version number matches the version
number of your memory card at the drive device.
Getting Started, 12/2018, 6SL3097-5AG30-0BP0