Setting Or Changing Web Server User Accounts - Siemens SINAMICS S120 Getting Started

Performing basic parameterization
6.1 Control Unit
If the web server does not respond, or if buttons are inactive or are not labeled, although the
converter is not fully utilized with internal calculations, load the web server page again as
follows:
● With the PC via <F5>
● With the smart phone or tablet via
6.1.1.3

Setting or changing web server user accounts

☐
For SINAMICS S120, the rights of both user accounts "SINAMICS" and "Administrator" are
permanently predefined and cannot be changed by users.
The user "Administrator" has full access rights by default. However, the standard
"SINAMICS" user only has restricted access rights.
For web server user accounts, you can make the following settings in Startdrive:
● Enable or disable a "SINAMICS" or "Administrator" user.
● Create a password for a "SINAMICS" or "Administrator" user.
● Change the password of a "SINAMICS" or "Administrator" user.
● Delete the password of a "SINAMICS" user.
Default password settings
● "SINAMICS" user: No password set.
For these users we recommend that a password is assigned. The password must
comprise at least 8 characters.
With a password, you prevent an attacker from assigning a password and thereby
blocking other commissioning engineers.
● "Administrator" user: No password set.
A password must be assigned for this user. The password must comprise at least 8
characters. If no password has been assigned, the following warning appears when
attempting to log on "A09000: Web server security: Administrator password not set".
Note
Secure passwords
The password must include the following elements to provide protection against
unauthorized access, e.g. unauthorized persons.
• At least 8 characters
• Uppercase and lowercase letters
• Numbers and special characters (e.g. ?!%+)
The password must not be used elsewhere.
118
"Drive control > Parameters > Basic parameterization > Web server"
Getting Started, 12/2018, 6SL3097-5AG30-0BP0