Table of Contents
Advertisement
Factory default
Reset the switch configuration on this page. Only the IP configuration is retained. The
new configuration is available immediately, which means that no restart is necessary.
Buttons
•
Click
Yes
to reset the configuration to factory defaults.
•
Click
No
to return to the main web page without resetting the configuration.
Note:
To reset the industrial managed switch to the factory default setting, you can also
press the hardware reset button at the front panel for more than 10 seconds. After the
device is rebooted, all configurations will be loaded to default setting including the IP
address. You can log in to the management web interface within the same subnet of
192.168.0.xx.
System reboot
The Restart Device page permits the device to be rebooted from a remote location.
After clicking the
Yes
later.
NS3550-8T-2S Industrial Managed Switch User Manual
button to restart, log in to the web interface about 60 seconds
Chapter 4: Web management
59
Advertisement
Table of Contents
Need help?
Do you have a question about the NS3550-8T-2S and is the answer not in the manual?