Interlogix NS3550-8T-2S User Manual page 430

Chapter 6: Command line mode
ERPS RPL Owner
Description:
Selection of RPL Block for a protection group
by default this node is considered as RPL Owner
(east|west) : select east(Port 0) or west(Port 1) as RPL Block
<group-id> : protection group id for selecting RPL Block.
Syntax:
Erps rpl owner <rpl_port> <group-id>
Parameters:
<rpl_port>: RPL Block
<group-id>: protection group id 1 - 64
ERPS RPL Neighbour Clear
Description:
make this node as non-neighbour for a protection group
<group-id> : protection group id for selecting RPL Block.
Syntax:
Erps rpl neighbour clear <group-id>
Parameters:
<group-id>: protection group id 1 - 64
ERPS RPL Owner Clear
Description:
making a node as Non-RPL Block for a protection group
After clear, this node is nore an rpl owner for the given group
(east|west) : selected east(Port 0) or west(Port 1) as RPL Block
<group-id> : protection group id for selecting RPL Block.
Syntax:
Erps rpl owner clear <group-id>
Parameters:
<group-id>: protection group id 1 - 64
ERPS Hold Off Timeout
Description:
configuring hold off timeout for a protection group
in milliseconds 0-10000 in the increments of 100ms
<hold_timeout>
<group-id>
Syntax:
Erps hold off timeout <hold_timeout> <group-id>
Parameters:
<hold_timeout>: timer timeout values
<group-id> : protection group id 1 - 64
ERPS Guard-timeout
Description:
configuring guard timeout for a protection group
428
: hold-off timeout
: protection group id for configuring hold-off time.
NS3550-8T-2S Industrial Managed Switch User Manual