Interlogix NS3550-8T-2S User Manual page 41

This page includes the following fields:
Object
User Name
Password
Password (again)
Privilege Level
Buttons
• Click Save to save changes.
• Click Reset to undo any changes made locally and revert to previously saved
values.
• Click Cancel to undo changes and return to the Users Configuration page.
• Click Delete User
configurations (i.e., add new user).
After a new user is added, the new user entry appears in the Users Configuration page.
Note: If a password is forgotten after changing the default password, press the reset
button on the front panel of the industrial managed switch for over 10 seconds and then
release it. The current settings, including VLAN, will be erased and the industrial
managed switch restores to default mode.
NS3550-8T-2S Industrial Managed Switch User Manual
Description
A string identifies the user name that this entry should belong to. The allowed
string length is 1 to 32. The valid user name is a combination of letters,
numbers, and underscores.
The password of the user. The allowed string length is
Type the user password again for confirmation.
The privilege level of the user.
The allowed range is 1
groups (i.e., it is granted full control of the device). But other values need to
refer to each group privilege level. User privileges should be the same or
greater than the group privilege level to have access to that group.
By default, most groups' privilege level 5 has read-only access and privilege
level 10 has read-write access. System maintenance (software upload, factory
defaults, etc.) requires user privilege level 15.
Generally, privilege level 15 can be used for an administrator account,
privilege level 10 for a standard user account, and privilege level 5 for a guest
account.
to delete the current user. This function is not available for new
to 15. If the privilege level value is 15, it can access all
Chapter 4: Web management
0 to 32.
39