Removing The Drive From The Drive Carrier - Dell EMC PowerEdge R740 Installation And Service Manual

Figure 53. Installing a 3.5 inch adapter into a 3.5 inch drive carrier
Next steps
1 Install a 3.5 inch drive carrier into the
2 Follow the procedure listed in

Removing the drive from the drive carrier

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the safety guidelines listed in
CAUTION: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
2 Lift the drive out of the drive carrier.
system.
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 99