Gpu Card Installation Guidelines - Dell EMC PowerEdge R740 Installation And Service Manual

3 Using Phillips #2 screwdriver, tighten the screw to secure the riser to the system.
Figure 86. Installing expansion card riser 3
Next steps
1 If removed, install expansion cards into the
2 Install the air shroud.
NOTE: If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
3 Follow the procedure listed in
4 Install any device drivers required for the card as described in the documentation for the card.

GPU card installation guidelines

• Ensure that both the processors are installed.
• The processor must use a GPU kit low-profile processor and heat sink module.
• To ensure adequate cooling when one or more GPUs are installed, the ambient inlet temperature is restricted to 30°C for CPU 150 W/8
C, 165 W/12 C, 200 W, 205 W. For more information, see the
• Ensure that the GPU enablement kit is available.
The GPU enablement kit includes:
– GPU air shroud
– Mylar
– Riser 3A
– GPU cable for riser 3A
– GPU cable for riser 2A
– Riser 2A
– Riser 1A or 1D
– GPU cable for riser 1A or 1D
– Two 1U processor and heat sink modules and two CPU clips
riser.
After working inside your system.
ambient temperature limitations
Installing and removing system components
section.
135