Back View Of The System - Dell EMC PowerEdge R740 Installation And Service Manual

Item Indicator, button, or
connector
2 USB port (2)
3 iDRAC Direct port
4 iDRAC Direct LED
5 VGA port
iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
iDRAC Direct LED indicator is located below the iDRAC Direct port on the right control panel.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. The
following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 9. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two
seconds and off for two
seconds)
Turns off

Back view of the system

The back view of the system provides access to the features available on the back of the server.
16 PowerEdge R740 system overview
Icon
N/A
Condition
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Description
NOTE: Press the power button to gracefully shut down an
ACPI-compliant operating system.
The USB ports are 4-pin, 2.0-compliant. These ports enable you to
connect USB devices to the system.
The iDRAC Direct port is micro USB 2.0-compliant. This port enables
you to access the iDRAC Direct features. For more information, see
the iDRAC User's Guide at Dell.com/poweredgemanuals.
The iDRAC Direct LED indicator lights up to indicate that the iDRAC
Direct port is connected. For more information, see
LED indicator codes section.
Enables you to connect a display device to the system. For more
information, see the Technical specification
the iDRAC Direct
section.