Recommended Tools - Dell EMC PowerEdge R740 Installation And Service Manual

Recommended tools

You need the following tools to perform the removal and installation procedures:
• Key to the bezel lock
The key is required only if your system includes a bezel.
• Phillips #1 screwdriver
• Phillips #2 screwdriver
• Torx #T30 screwdriver
• 1/4 inch flat blade screwdriver
• Wrist-grounding strap connected to the ground
• ESD Mat
You need the following tools to assemble the cables for a DC power supply unit:
• AMP 90871-1 hand-crimping tool or equivalent
• Tyco Electronics 58433-3 or equivalent
• Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
Optional front bezel
Front bezel details
An optional metal bezel is mounted on the front of the system to display system branding. A lock on the bezel is used to protect
unauthorized access to the drives. There are two versions of bezel available:
• With LCD panel
• Without LCD panel
For bezels with LCD panel, the system status can be viewed on the LCD panel. For more information, see the
The LCD bezel is hot pluggable and can be used in any server of the same branding even if that system was originally not ordered with that
LCD bezel.
Removing the front bezel
The procedure to remove the front bezel with and without the LCD panel is the same.
Prerequisite
Follow the safety guidelines listed in
Steps
1 Unlock the bezel by using the bezel key.
2 Press the release button, and pull the left end of the bezel.
3 Unhook the right end, and remove the bezel.
70 Installing and removing system components
Safety instructions.
LCD panel section.