Removing Usb 3.0 Module - Dell EMC PowerEdge R740 Installation And Service Manual

Removing USB 3.0 module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the backplane
4 Remove the cooling fan
5 Remove the air shroud.
6 Remove the internal USB memory
NOTE: The position of the USB 3.0 module may vary depending on the configuration of your
system.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route these cables
properly when you replace them to prevent them from being pinched or crimped.
Steps
1 Disconnect the cables from the system board.
2 Using Phillips #2 screwdriver, loosen the screw on the USB 3.0 module.
3 Slide the USB 3.0 module out of the system.
Figure 123. Removing USB 3.0 module
Next step
Install the USB 3.0 module.
Installing USB 3.0 module
Prerequisite
Follow the safety guidelines listed in
NOTE: The position of the USB 3.0 module may vary depending on the configuration of your system.
Safety instructions.
Before working inside your
cover.
assembly.
key.
Safety instructions.
system.
Installing and removing system components 165