Removing The Right Control Panel - Dell EMC PowerEdge R740 Installation And Service Manual

Figure 135. Installing left control panel
Next steps
1 Install the air shroud.
2 Install the cooling fan
3 Follow the procedure listed in

Removing the right control panel

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the cooling fan
Steps
1 Disconnect the VGA cable from the system board.
2 Pull the cable latch and disconnect the control panel cable from the system board connector.
3 Using Phillips #1 screwdriver, remove the screws that secure the control panel and cable tube to the system.
4 Holding the control panel and cable tube by its sides, remove the control panel and cable tube away from the system.
assembly.
After working inside your
Safety instructions.
Before working inside your
assembly.
system.
system.
Installing and removing system components 183