Installing Nvdimm-N Battery Into Mid Drive Tray - Dell EMC PowerEdge R740 Installation And Service Manual

Figure 42. Removing NVDIMM-N battery from mid drive tray
Next step
Install NVDIMM-N battery into mid drive

Installing NVDIMM-N battery into mid drive tray

Prerequisites
Follow the safety guidelines listed in
CAUTION: NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure that your
system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off before installing the NVDIMM-N
battery.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a
battery.
Steps
1 Connect the cables to the NVDIMM-N battery.
2 Slide the NVDIMM-N battery to engage the battery with the drive tray.
3 Using Phillips #2 screwdriver, tighten the screw to secure the NVDIMM-N battery.
4 Lower the drive tray handle.
tray.
Safety instructions.
Installing and removing system components 89