M.2 Ssd Module - Dell EMC PowerEdge R740 Installation And Service Manual

b For easier handling, peel off a small section of the adhesive cover and align the mylar foam with the system cover.
c Remove rest of the adhesive cover and install mylar foam on the system cover.
d Press along the length of the mylar foam to ensure that it is rmly affixed to the system cover.
Figure 98. Installing mylar foam on the system cover
3 Follow the procedure listed in

M.2 SSD module

Removing the M.2 SSD module
Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the BOSS card.
NOTE: Removing the BOSS card is similar to the procedure for removing an expansion card riser.
Steps
1 Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
2 Pull the M.2 SSD module away from the BOSS card.
144 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.