Removing Riser 2 And 3 Blank - Dell EMC PowerEdge R740 Installation And Service Manual

Figure 74. Installing expansion card into expansion card riser 3
Next steps
1 If applicable, connect the cables to the expansion card.
2 If applicable, install the air
3 Follow the procedure listed in
4 Install any device drivers required for the card as described in the documentation for the card.

Removing riser 2 and 3 blank

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
Steps
1 Using Phillips #2 screwdriver, loosen the screws (3) that secure the blank to the system.
2 Press the release tab, and holding the blank by its edges, lift the blank away from the system.
shroud.
After working inside your
Safety instructions.
Before working inside your
system.
system.
Installing and removing system components 125