Removing Riser 3 Blank - Dell EMC PowerEdge R740 Installation And Service Manual

Figure 76. Installing riser 2 and 3 blank
Next steps
1 Install the air shroud.
2 Follow the procedure listed in

Removing riser 3 blank

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
Steps
1 Using Phillips #2 screwdriver, loosen the screw that secures the blank to the system.
2 Lift the blank away from the system.
After working inside your system.
Safety instructions.
Before working inside your system.
Installing and removing system components 127