Figure 100. Installing the M.2 SSD module
Next steps
1
Install the BOSS card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2
Install the air shroud
.
3
Follow the procedure listed in
Optional IDSDM or vFlash module
Removing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot.
To locate IDSDM/vFlash module, see the
2
Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Next step
Install the MicroSD
card.
146
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
System board jumpers and connectors
system.
section.