Table of Contents
Advertisement
Installation
Installation, cont'd
Installation Overview
To install and set up the CD 900 quad-standard decoder for
operation, follow these steps:
Turn off all of the equipment. Ensure that the video
1
sources (DVD players, laserdisc players, VCRs, satellite
receivers, or other devices) and the output display are all
turned off and disconnected from the power source.
Mount the switcher. See "Mounting the CD 900" in this
2
chapter.
Attach the cables. See "Rear Panel Cabling" in this
3
chapter.
Connect power cords and turn on the display device and
4
the input devices, in that order.
Set the rear panel DIP and sync switches. See "Setting up
5
the CD 900/Rear Panel Controls" in chapter 3.
Select an input and adjust the picture controls on the front
6
panel. See "Front Panel Controls and Indicators" in
chapter 3.
Mounting the CD 900
1.
For optional rack mounting, mount the CD 900 on the left
or right side of a 19" 1U Universal Rack Shelf (Extron
part #60-190-01) (figure 2).
4-40 X 1/8 Screws
Use 2 Mounting Holes
on Opposite Corners
Figure 2 — Rack mounting the CD 900
a.
If feet were previously installed on the bottom of the
case, remove them.
CD 900 Decoder • Installation
2-2
False Front Panel
Uses 2 Front Holes Only
b.
Mount the CD 900 on the rack shelf, using two
4-40 x 1/8 screws in opposite (diagonal) corners to
secure the case to the shelf.
2.
If desired, attach a false front panel, or a second ½-rack-
width device to the other side of the shelf.
3.
Attach the rack shelf to the rack using four 10-32 x ¾" bolts
and four #10 beveled dress washers.
Rear Panel Cabling
All connectors are on the rear panel. Figure 3 shows the cable
connections on the rear panel of the CD 900 decoder.
100-240VAC~50/60Hz
AUTO SW
SPARE
INPUTS
SPARE
RGB/COMP
SERR REM
H+
V+
X MODE
0.1A MAX
1
2
Figure 3 — Rear panel cabling
Power connection
AC power connector — Plug a standard IEC power cord into
1
this connector to connect the CD 900 to a 100 to 240VAC, 50 Hz
or 60 Hz power source.
Signal input and output connections
Input connectors
2
Input 1, composite video connector — Connect composite
video to this BNC connector.
Input 2, S-video connector — Connect S-video to this 4-pin
mini DIN connector.
Output connectors
3
RGBHV video connection — For RGBHV video, connect
to all five BNC connectors as show in figure 4. Ensure the
RGB/Component DIP switch is in the right position and
that the H/HV/SOG is in the H position (see "Setting Up
the CD 900/Rear Panel Controls" in chapter 3).
RGBS video connection — For RGBS video, connect to the
four BNC connectors shown in figure 5. Ensure the
RGB/Component DIP switch is in the right position and
CD 900 Decoder • Installation
LISTED
1T23
C
US
I.T.E.
OUTPUT
RS-232
H
H/V
R/P
G
B/P
H/HV
SOG
V
REMOTE
R
B
3
4
2-3
Advertisement
Table of Contents
