Uneven Density Within 107 Mm (4.2 Inches) Of The Trailing Edge - Ricoh Pro C9100 Operating Instructions Manual

7. Image Quality Problem: Full Page
3. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.

Uneven Density within 107 mm (4.2 inches) of the Trailing Edge

Printing in the area extending approximately 107 mm (4.2 inches) from the trailing edge is fainter or
denser.
Cause:
This may occur if:
• Printing is done at low temperature or humidity
• Halfttone printing
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
The solution depends on whether the area within 107 mm (4.2 inches) of the trailing edge is denser or
fainter.
78
107 mm
(4.2 in.)
107 mm
(4.2 in.)
DFT032