Other Paper Delivery Problems - Ricoh Pro C9100 Operating Instructions Manual

8. Troubleshooting Paper Delivery Problems
Two-tray wide LCT (Vacuum Feed LCIT RT5100) is used.
The factory-set airflow of the wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
For details see, page 105 "If (J430/J431/J445/J446/J460/J461) Appears".

Other Paper Delivery Problems

If the Paper Jams in the Fusing Unit during Duplex Printing
A paper jam has occurred at the separation claw.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
1. In [Advanced Settings] for the custom paper, check the present value in 014: [Erase
Margin: Trailing Edge]. Is it lower than 3 mm?
Yes In 014: [Erase Margin: Trailing Edge], adjust the trailing edge margin to make it 3 mm
or longer.
No Contact your service representative.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
112