11. Advanced Instructions
Prepunched Paper
When using pre-punched paper, the pre-punched holes may be wrongly detected as paper edge and
jam code J097 or J098 appears.
If this happens, carry out the following settings;
• For details about specifying settings in the [Advanced Settings] menu, see "Details of Menu Items in
Advanced Settings", Adjustment Item Menu Guide.
Are you using the right kind of
pre-punched paper?
For details, see the "Guide to
Paper".
Where do you have the punch
position to the paper feed direction?
Position 1
Position 1: Side away from the control
Position 2: Control panel side
Position 3: Leading/trailing edge
Change the setting to the setting shown
in Table 1 or Table 2, depending on the
paper size and number of holes.
For position 2, see Table 1.
For position 3, see Table 2.
Was the problem resolved?
176
Yes
panel (Unconditional,
recommended)
(Conditional)
(Conditional)
Position 2 or 3
Print the image.
No
Yes
Finished!
Where do you have the punch
position to the paper feed direction?
No
Position 1: Side away from the control
panel (Unconditional,
recommended)
Position 2: Control panel side
(Conditional)
Position 3: Leading/trailing edge
(Conditional)
See Fig. 1.
If the punched holes are located at any
of positions A to G, depending on their
locations, change the setting to the
setting shown in Fig. 1.
Contact your service representative.
Position 1
Position 2 or 3
DFT065