5. Image Quality Problem: Lines
Cause:
The amount of lubricant on the intermediate transfer belt is uneven.
This may occur on half-tone images.
Solution:
1.
In the 02: [Machine: Image Quality] group on the [Adjustment Settings for Skilled
Operators] menu, select 0201: [Adjust Image Density/ DEMS] and execute [Image
Density Adjustment: Manual Execute].
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Repeat Steps 1 and 2. If the problem persists, contact your service representative.
Horizontal Streaks at the Area within 20 mm (0.8 inches) from the Leading
Edge
An area within approximately 20 mm (0.8 inches) from the leading edge of the paper may be affected
by thick density, insufficient density, toner blasting, or streaks.
52
DFT305