If (J430/J431/J445/J446/J460/J461) Appears - Ricoh Pro C9100 Operating Instructions Manual

Yes Repeat Step 2. If the problem persists even though you have increased the value
by "10", set 115: [Ppr Edge Detection: Sensing Duration] to [Long Time] and
proceed the steps in "Procedure 2: If set to [Long Time]".
No Go to the next step.
4. Decrease the value in 116: [Ppr Edge Detection: Sensitivity] by 0.5 points.
5. Print 50 sheets on one side. Has the jam code J098 appeared?
Yes Increase the value in 116: [Ppr Edge Detection: Sensitivity] by 0.5 points.
No Repeat Steps 4 and 5.
Paper with a width of 160 mm (6.3 inches) is being used.
Perform the solution in page 107 "Paper Skew", "Paper with a width of 160 mm (6.3 inches) is being
used.".

If (J430/J431/J445/J446/J460/J461) Appears

This indicates a paper misfeed when using the two-tray wide LCT (Vacuum Feed LCIT RT5100).
Paper misfeeding may be resolved by printing an original repeatedly.
If the jam code (J430/J431/J445/J446/J460/J461) appears more than 3 times, follow the
procedure below:
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
The factory- set airflow of the wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
1. Set 112: [Paper Tray: Paper Feed Mode] to [Moderate Nonfdg Red. (Higher)] in
[Advanced Settings] for the custom paper.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Step 2. If the jam code appears more than 3 times, set 112: [Paper Tray: Paper
Feed Mode] to [Max Nonfdng Reduc. (Highest)].
The Jam Code Appears
105