If (J086) Appears - Ricoh Pro C9100 Operating Instructions Manual

• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
• When prepunched paper is used, see page 176 "Prepunched Paper".
Solution:
1. In [Advanced Settings] for the custom paper, set 114: [Registration Gate Position Setting]
to"-2".
2. Print the image on both sides of 50 sheets.
3. Has the jam code J097, J098 or J048 appeared?
If (J097) or (J098) appears
If (J048) appears
If no jam code appears
4. Print the image on both sides of 50 sheets.
5. Has the jam code J097, J098 or J048 appeared?
Yes Contact your service representative.
No Finished!

If (J086) Appears

Cause:
Paper is jammed near the fusing unit exit.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
1. In [Advanced Settings] for the custom paper, decrease the value in 095: [Additional
Fusing Temp 2] by 5 degrees.
Contact your service representative.
Set 114: [Registration Gate Position Setting]
to"-1".
Finished!
The Jam Code Appears
101