3.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Proceed to "Procedure 2: Increase the fusing heat roller temperature".
Procedure 2: Increase the fusing heat roller temperature
1.
In [Advanced Settings] for the custom paper, adjust the fusing heat roller temperature.
<Printing in full color>
Increase the value in 088: [Fusing Temp: FC] by 5 degrees.
<Printing in black and white>
Increase the value in 089: [Fusing Temp: BW] by 5 degrees.
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Increase the value by 5 degrees in 088: [Fusing Temp: FC] or 089: [Fusing Temp:
BW]. If the problem persists even though you have increased the value by 185
degrees, contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller. For details see, page 159 "Operating Procedure for Color Calibration".
Uneven Gloss: Foggy
Glossiness is insufficient at the trailing edge of the blank area.
Uneven Density
85